Toshiba D-VR17KB VCR User Manual


 
40
EN
8 Press [VCR].
Make sure to select a recording mode using
[REC MODE]. (See page 72.)
Rewind or fast forward the tape to the point where
you want to start recording.
9 Press [DUBBING].
DVD to VCR duplication will start.
10
Press [STOP S] to stop the
recording.
Note
NTSC dubbing is prohibited in this unit.
Dubbing Mode is available only if the tape or disc is
not copy-protected.
You cannot change the output mode during VCR to
DVD or DVD to VCR duplication.
If you want to watch the duplicated material, after
the DVD to VCR duplication, press [VCR] first and
then press [PLAY P].
Setting a Disc to Protect
To prevent accidental over-recording, editing or
erasing of recordings, you can protect them using the
Setup menu.
Insert a recordable disc.
1 In stop mode, press [SETUP].
2 Select “DVD Menu” using [U / D],
then press [ENTER].
3 Select “Disc Protect OFF ON”
using [U / D], then press [ENTER].
4 Select “Yes” using [U / D], then
press [ENTER].
The disc is protected.
5 Press [SETUP] to exit.
Note
The Disc Protect setting is available only when a
disc recorded in VR or +VR mode is inserted.
You can select only “Disc Protect ON
OFF”
when a protected disc is inserted.
To cancel the disc protect:
Select “Disc Protect ON OFF” at step 3, then
select “Yes”.
If you insert a disc protected with this unit, “Disc
Protect ON
OFF” will appear instead of
“OFF ON”.
DVD-RWDVD-RW
VR
DVD+RWDVD+RW D
D
VD+R
VD+R
DVD+R
E9GA0BD_EN.book Page 40 Monday, March 26, 2007 10:14 AM