Toshiba D-VR17KB VCR User Manual


 
EN
Introduction Connections Basic Setup Playback
Editing
VCR Functions Others
Function Setup
Recording
73
Accidental erasure prevention
To prevent accidental recording on a recorded
cassette, remove its record tab. To record on it later,
cover the hole with cellophane tape.
One-touch Timer Recording
This feature allows you to set the recording length
simply by pressing [REC I].
1 Turn on the unit and insert a
recordable tape.
Make sure that the TV input is set on the unit.
2 Press [VCR].
3 Select the recording mode using
[REC MODE]. (See page 72.)
4 Select the desired channel to record
using [PROG.
/ ] or
[the Number buttons].
5 Press [REC I] repeatedly until the
desired recording time (30 minutes
to 8 hours) appears on the TV
screen.
One-touch Timer Recording will start.
When the unit reaches the specified time, it will be
turned off automatically.
To change the recording length during One-touch
Timer Recording, press [REC I] repeatedly until the
desired length appears.
To cancel One-touch Timer Recording within the
specified time, press [STOP S].
Hint
The remaining recording time will appear on the TV
screen during One-touch Timer Recording. Press
[DISPLAY] to see it on the TV screen.
Note
If VCR One-touch Timer Recording is completed
during DVD playback or recording, the VCR will be
in stop mode and the DVD keeps the current mode.
You cannot use the pause function during One-
touch Timer Recording.
When One-touch Timer Recording is finished and
the power is turned off, the unit will switch to the
timer-standby mode automatically if a timer
recording has been programmed. Press
[TIMER SET] to cancel the timer-standby mode in
order to use the unit continuously.
Search
Index Search
1 Press [VCR].
2 Press [SEARCH] so that the index
search menu appears.
3 Enter the number of recordings you
wish to skip using
[the Number buttons] within 30
seconds.
4 Press [FWD f] or [REV r] to start
index search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After index search, the VCR will play back the
tape automatically.
Note
This function is not available during recording.
Every time a tape is recorded, an index mark is
written on the tape.
You can make the index mark up to 20.
Time Search
This feature allows you to go to a specific point on a
tape by entering the exact amount of time you wish to
skip in order to reach the point.
1 Press [VCR].
2 Press [SEARCH] repeatedly until the
time search menu appears.
3 Enter your desired time to skip using
[the Number buttons] within 30
seconds.
4 Press [FWD f] or [REV r] to start
time search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After time search, the unit will play back the tape
automatically.
Note
This function is not available during recording.
•Press [STOP S] to stop the search.
If the tape reaches the end during the search, this
unit will cancel it and rewind the tape.
You can set the time up to 9:59.
Record tab
VCRVCR
0:30
8:00 7:30
1:00
Normal Recording
VCRVCR
VCRVCR
E9GA0BD_EN.book Page 73 Monday, March 26, 2007 10:14 AM