Toshiba D-VR17KB VCR User Manual


 
EN
74
Other Operations
Press [VCR] first.
To cue or review picture during playback
(Picture Search):
Press [FWD f] or [REV r] during playback.
Press it again and the unit will search in super high
speed (in the LP mode only).
To freeze the picture on TV screen during
playback (Still mode):
Press [PAUSE p]. Each time you press the button,
the picture will be forwarded frame by frame.
If the picture begins to vibrate vertically during the still
mode, stabilise the picture by pressing the
[PROG. / ].
If the picture is distorted or rolling vertically, adjust the
vertical hold control on your TV, if equipped.
To reset the tape counter:
Press [CLEAR].
To play back in slow forward motion:
During playback, press [PAUSE p], then press
[FWD f].
If the noise bars appear on the TV screen, you can
reduce it by pressing [PROG. / ]. Slow reverse
is not available in VCR mode.
To repeat a playback indefinitely without touching
[PLAY P] (Auto Repeat Playback):
During normal playback, press [REPEAT]. When a
tape is played to its end, the tape will rewind to the
beginning and start playback itself. To cancel the Auto
Repeat Playback, press [REPEAT] again.
Note
Still / Slow / Pause mode will be automatically
cancelled after 5 minutes to prevent damage to the
tape and the video head.
To return to normal play back from the Picture
Search / Still / Slow mode, press [PLAY P].
Hi-Fi Stereo Sound System
This unit will record and playback Hi-Fi stereo sound.
In addition, it has a NICAM stereo sound decoder.
This unit will receive stereo and bilingual broadcasts
and it is possible to record in several ways and to play
back the sound.
Selecting the Sound Mode
You can select each mode by pressing [AUDIO ]
on the remote control. Each mode is indicated on the
TV screen as following.
During playback of the recorded tape in Hi-Fi mode
During reception of stereo broadcasts
During reception of bilingual broadcasts
Note
If you play back non-Hi-Fi tapes, the unit will play
back automatically in monaural even if you select
any mode.
If the stereo signal becomes weak, the broadcast is
automatically recorded in monaural.
VCRVCR
Mode Audio output
Display on
the TV screen
Stereo Stereo STEREO
L L audio from both speakers LEFT
R R audio from both speakers RIGHT
Normal Monaural MONO
Mode Audio output
Display on
the TV screen
Main
Main audio from the both
speakers
Main
Sub
Sub audio from the both
speakers
Sub
Main /
Sub
• Main audio from the left
speaker
• Sub audio from the right
speaker
Main
Sub
E9GA0BD_EN.book Page 74 Monday, March 26, 2007 10:14 AM