Toshiba D-VR17KB VCR User Manual


 
EN
Introduction Connections Basic Setup Playback
Editing
VCR Functions Others
Function Setup
Recording
67
Set to “ON” to make the dynamic range narrower.
Select a setting using [U / D], then
press [ENTER].
Your setting is activated.
The Dynamic Range Control function is effective
only with analogue audio connection.
Note
The Dynamic Range Control function is available
only on discs recorded in the Dolby Digital format.
Select a setting using [U / D], then
press [ENTER].
Your setting is activated.
48kHz: If your amplifier / decoder is NOT compatible
with 96 kHz PCM, select “48kHz”. Sound
recorded at 96 kHz is down sampled to
48 kHz.
96kHz: If your amplifier / decoder is compatible with
96 kHz PCM, select “96kHz”. Sound is
sampled at 96 kHz.
Note
When playing back a disc with copyright protection:
Even if you select “96kHz”, the sound is down
sampled to 48 kHz.
Select a setting using [U / D], then
press [ENTER].
Your setting is activated.
PCM: Converts the Dolby Digital into PCM
(2 channel).
If your amplifier / decoder is NOT compatible
with Dolby Digital, set to “PCM”.
Stream: Outputs Dolby Digital signals.
If your amplifier / decoder is compatible with
Dolby Digital, set to “Stream”.
Hint
When playing back a DVD-RW disc recorded in VR
mode:
If the audio source on a disc is in Dolby Digital
format, set “Dolby Digital” to “PCM” so that you can
switch to main audio (L), sub audio (R), or a
combination of both (L / R) using your amplifier /
decoder.
Select a setting using [U / D], then
press [ENTER].
Your setting is activated.
PCM: Converts MPEG into PCM.
If your amplifier / decoder is NOT compatible
with MPEG, set to “PCM”.
Stream: Outputs MPEG Audio signals.
If your amplifier / decoder is compatible with
MPEG, set to “Stream”.
Select a setting using [U / D], then
press [ENTER].
Your setting is activated.
ON: Outputs DTS signals.
If your amplifier / decoder is compatible with
DTS, set to “ON”.
OFF: No DTS signal is output.
If your amplifier / decoder is NOT compatible
with DTS, set to “OFF”.
3. Disc Menu Language (Default: English)
Set the Disc Menu language.
Select a language using [U / D],
then press [ENTER].
Your setting is activated.
4. Audio Language (Default: Original)
Set the Audio language.
Select a language using [U / D],
then press [ENTER].
Your setting is activated.
If “Original” is selected, the audio language is the
default of the inserted disc.
Dynamic Range Control (Default: ON)
PCM sampling (Default: 48kHz)
Dolby Digital conversion (Default: Stream)
Dynamic Range Control
ON
OFF
PCM
48kHz
96kHz
Dolby Digital
PCM
Stream
Settings for MPEG (Default: PCM)
Settings for DTS (Default: ON)
MPEG
PCM
Stream
DTS
ON
OFF
Disc Menu Language
English
Other
Audio Language
Original
English
Other
E9GA0BD_EN.book Page 67 Monday, March 26, 2007 10:14 AM