Filter
Top Products
6
2.1 Installing the DVI Board or SDI Board
Clarity Visual Systems ships the DVI or SDI board separately from the Bay Cat X to some customers and for field
upgrades.
✎
The DVI Board is the field-installed video board for
the Video Model of Bay Cat X. The SDI Board is
the field-installed video board for the Broadcast
Model of Bay Cat X.
1. If you powered up the unit to confirm proper working
order upon receipt, turn off AC power to the Bay Cat X
and remove the power cord.
2. Place the unit face down on a flat surface on something
soft and non-scratching. If your unit does not have a
protective face glass panel, be EXTREMELY careful as
the LCD material can be scratched.
3. Confirm that your DVI Board package contains four (4)
mounting screws (SDI Board package contains six[6]
srcews), a replacement DVI or SDI cover panel, and a
disposable grounding wrist strap.
4. On the back of the Bay Cat X, remove the blank cover
panel.
a) Unscrew the two screws holding the blank panel in
place. Save the screws for the replacement panel you
will install later.
b) Remove the blank panel by pushing down slightly
on the inserted end of the panel as you pull it out.
c) Recycle the blank panel with other aluminum scrap
metal.
5. Attach the grounding wrist strap to bare metal on the
chassis. Using standard ESD procedures, remove the
As you remove the panel,
push down slightly on this
end of the panel as you pull
it towards you