Filter
Top Products
21
✎ TIP: The FREQ/PHASE button opens the Picture
menu directly.
4. Select Source and press E
NTER. This opens the
Source menu (the menu shown below is from the
Video Model; the Broadcast Model and Base Model
have different options):
5. With the arrow keys, select the input connector you
want:
6. Press
ENTER. The Bay Cat X will immediately display
the picture. Within a second or two the Bay Cat X will
analyze the picture and adjust to it.
If you see no picture …
• Check the source by connecting it to another type of
display. If the source is a laptop, maybe it has timed out
and the screen is blank. Did you enable the VGA output
on the rear of the laptop?
• Check the power switch near the AC power cord. It
should be lit.
• The IR receiver for the remote is a small hole in the
lower left corner of the display. Be sure the remote is
aimed toward it. (In Portrait orientation the IR receiver
is in the lower left corner.
About the remote
The remote control operates with IR (infra-red) signals
going to the IR receiver. The receiver is in the lower right
corner (in landscape mode; in portrait mode, it is in the
lower left corner) of the screen bezel behind a small hole.
(Later, to prevent accidental adjustment of the display,
disable the remote control function using an RS232 com-
mand.)
A quick reference for all the remote buttons is found in
“Remote Control Buttons” on page 106.
If the remote doesn’t work
• The batteries in the remote are dead or installed wrong.
• The remote was not aimed at the screen.
• Something is blocking the IR receiver in the Bay Cat X.
• IR remote action was disabled by an RS232 command.
✎ The remote control has a large spread of its IR
radiation. It is difficult from a distance to control
only one Bay Cat X in an array. Step closer.
Analog
Digital
Component (YPbPr)
S-Video
Composite
All Models Analog, usually computer sources,
VGA through UXGA
Video and Broadcast models have the following addi-
tional choices:
Video Model Digital (DVI connector)
Broadcast Model SDI (SDI In/Out ports)
Video and Broad-
cast models
Component
Composite Video
S-Video
Landscape
Portrait
IR Receiver