Filter
Top Products
53
• When you press the SETUP button.
Retry on lost signal occurs only when the present signal
(picture) disappears or changes in some way. If this item is
not checked, the Bay Cat X will not try to sync to a new
signal. Keep this menu item checked.
Note that searching will not happen just because the pic-
ture goes black. Black, from video or from a computer, is a
valid picture. The signal itself (the sync pulses) must be lost
to trigger a search.
The several Do items in this menu will, if checked, happen
in these situations:
• If a new signal is acquired, either through a search to a
different connector or because source picture changed
modes, such as from WXGA to UXGA, each of the
checked items occurs in the order listed in the menu.
• When you press the
SETUP button on the remote, each
of the checked actions occurs in the order given in the
menu.
Do Quick Black/White Levels searches for the bright-
est and darkest pixels in the picture and adjusts to these.
Black and White Levels are best done semi-automatically
(see “Adjusting Levels for Analog Computer Sources” on
page 28) so leave this unchecked.
Do Frequency and Do Phase find the frequency and
phase (separately) of the computer picture and adjust to
them. This works best on a picture that has lots of sharp
changes in brightness, such as text (adjacent white and
black pixels).
Do Position centers the picture on the screen.
About the input memories
The Bay Cat X has a ten input memories for storing the
most recent attributes of the pictures it displays. When a
new picture arrives that is near enough to a previous type, it
uses the stored attributes rather than automatically adjust-
ing brightness, contrast, frequency, etc.
For example, suppose the Bay Cat X sees an analog
WXGA picture and auto-adjusts everything in the Auto
Options Menu. Then you change the Brightness and Con-
trast. Then you change computers and feed in a UXGA pic-
ture.
If you now switch back to the computer with the WXGA
picture, Bay Cat X will use the Brightness, Contrast, as
well as other settings, from the last time it saw a WXGA
picture.
✎ Aspect Ratio is specific to the source, which
means it applies to all modes. It does not change
when the system recalls a memory from cache.
Setup button
The
SETUP button on the remote starts the “Do” pro-
cesses. Each Do that is checked will begin, one at a
time, until all are adjustments completed.
Logo Capture
The capture menu is used to create a custom splash
screen that appears when the unit is turned on or the CUR-
TAIN button is pressed and in the Miscellaneous menu
(see “Advanced Options > Miscellaneous Settings” on
page 94), Curtain Pattern is set to Logo.
To capture a screen image, do the following:
1. Display the image you want to capture.
✎ You may capture a portion of the image or the
entire screen; the larger the area captured the
longer the process.
2. On the Logo Capture menu (Main > Advanced >
Capture Custom Logo) select Position to specify the
on-screen position for the custom splash screen.
Choices are:
Logo Capture
Position Top Left
Scaling One to One
RLE compression factor 1
Move Area Up/Down
Move Area Left/Right
Shrink/Grow Height
Shrink/Grow Width
Start Capture
Restore Factory Logo
Middle Left Centered top/bottom at the left side of the
screen
Middle Center Centered on the screen, both top/bottom
and left/right
Middle Right Centered for top/bottom, at the right side
of the screen
Bottom Left At the bottom left corner of the screen