Filter
Top Products
85
Unit Status Settings
Setting Description
Asset Tag An optional user settable field which is set via the RS-232 port. This could be a serial num-
ber, name or any other piece of information desired
Backlight Status Shows OK if the electronics module detects that both banks of backlights are functioning
normally. Shows Failed if one or both of the backlight banks is not drawing the correct
amount of current
Internal Temperature The current internal temperature at one point on the electronic module. This is not neces-
sarily the highest nor the lowest temperature point of the unit, nor is it an indicator of ambi-
ent temperatures.
If thermal guidelines (see “Normal Use Thermal Guidelines” on page 116) are exceeded
and additional ventilation or cooling has been implemented, this temperature may be used
as a datapoint to determine if the temperature of the unit is being affected.
Mode ID The index into the internal mode table found for the incoming signal. This is used in diagno-
sis of mode detection problems
HPer The measured horizontal period of the incoming signal. This is used in diagnosis of mode
detection problems
VLines The number of horizontal lines detected per vertical period. This is used in diagnosis of
mode detection problems