Filter
Top Products
22
FR-2
Field Memory Recorder (Chapter 2: Before using the FR-2)
According to the situation, you can turn the display backlight on or off, as well as adjust
the display contrast.
Turning the backlight on or off
[RIGHT] key
Adjusting the display contrast
<Note>:
When operating the unit on batteries, to save the battery power, we recom-
mend not keeping the backlight lighting unless it is necessary.
1) When the FR-2 is stopped, press the [LIGHT] key while holding down the [SHIFT] key.
The current contrast value is shown at the position where the current file name is
usually shown (pointed by the arrow below).
2) Rotate the [MENU] dial to adjust the display contrast (adjustable level: 0 to 63).
Rotating the [MENU] dial changes the contrast in realtime.
The lower the contrast value, the lower the contrast is.
The higher the value, the higher the contrast is.
3) Press the [ENTER] key to fix the contrast value.
The display returns to show the previous Home screen, while the selected contrast
value is stored to the Flash ROM. If you do not press the [ENTER] key for five seconds
after adjusting the contrast, the display returns to show the Home screen and the
contrast value is stored automatically.
REC STBY REC
0
1
2
3
46
7
8
9
10
5
ACCESS
PEAK
R
L
SHIFT
/ENTER
RELEASE
CARD
MENU
HOME /
FILE
CUE
PREV.
NEXT
CONTRAST
DEL CUE
LIGHT MARK CUE
HOLD RESET
FR-2 FIELD MEMORY RECORDER
PHONES
MONITOR
MAXOFF
SP/HP
[SHIFT] key
Setting the display backlight/contrast
By pressing the [LIGHT] key on the front panel, the display backlight turns on for
three seconds and then automatically turns off.
By pressing and holding the [LIGHT] key for more than two second, the backlight
turns on and keeps lighting. To turn off the backlight, press the [LIGHT] key again.
While the unit is stopped, you can adjust the display contrast by following the
procedure below.