Filter
Top Products
83
FR-2
Field Memory Recorder (Chapter 6: MENU mode/Setup menu)
3) Move the character selection cursor to "OK" and press the [ENTER] key.
After the FR-2 stores the entered name immediately, "Completed!" is shown on the screen
and the display returns to show the scene name list screen.
• Selecting Take number
2) Use the [MENU] dial to select the desired Take number and press the [ENTER] key.
You can select a Take number between 001 and 999.
Pressing the [ENTER] key fixes the selection and the display returns to the previous screen.
• Renaming the scene name
2) Enter the desired scene name.
See the table below for details about how to enter a name. Up to 15 characters can be
entered.
The cursor in [ ] is called "scene name cursor", while the cursor in the character options
is called "character selection cursor".
You can move the character selection cursor by using the [MENU] dial.
To edit a character
highlighted (on the
cursor position)
Use the [MENU] dial to select a desired character from among the character options,
and press the [ENTER] key. The selection is fixed and the scene name cursor moves
right.
To move the scene
name cursor position
Use [I<<] or [>>I] key. Or use the [MENU] dial to select "<-" or "->" in the character
options, and press the [ENTER] key.
Inserts a front space
at the scene name
cursor position
After moving the scene name cursor to the desired position, move the character
selection cursor to "INS" at the bottom, and press the [ENTER] key.(The FR-2 is put
into the INSERT mode and the scene name cursor condition changes to be lit solid.)
After that, select the character that you would like to insert by the character selection
cursor and press the [ENTER] key again. In order to cancel the INSERT mode,
select the "INS" and then the [ENTER] key. (The scene name cursor condition
changes to be flashing.)
To delete a character
on the scene name
cursor position
After moving the scene name cursor to the desired position, move the character
selection cursor to "DEL" at the bottom, and press the [ENTER] key.
1) Select "Take No." and press the [ENTER] key.
The current Take number starts flashing (by default, "001" flashes).
1) Select "Rename" and press the [ENTER] key.
The display now shows the screen on which you can edit the selected scene name (Scene01).