Filter
Top Products
49
FR-2
Field Memory Recorder (Chapter 5: Recording/playback)
The FR-2 is equipped with the high-pass filter circuit. The cutoff frequency is 100
Hz and the filter slope is -12 dB/oct. The [HPF] switch, which selects ON or OFF of
the high-pass filter, is provided for each channel.
The filter is useful to eliminate the wind noise during location recording or unnec-
essary low frequency noise when recording a voice or sound.
High-pass Filter
[LINE/MIC] switches
Using the [TRIM] control for each (L, R) channel, you can adjust the input gain for
the associated channel to accept signal within the following nominal input level
range.
Adjusting the input gain
When the [LINE/MIC] switch is set to "LINE"
When the [LINE/MIC] switch is set to "MIC"
Between -60 dBu and -26 dBu
Between -30 dBu and +4 dBu
Set the [LINE/MIC] switch for each (L, R) channel appropriately according to the
source (microphone or line) connected to the associated [ANALOG IN] (L/MONO
or R) connector.
Selecting the input source
Recording analog audio
To record analog audio, some control and switch settings are necessary.
176.4
192
96
88.2
MIC
LINELINE
MIC
-26
-60+4
-30
PRE REC
ON
OFF
LINE
/MIC
FS(kHz)
ST
MONO
TRACK MODE
24BIT
16BIT
QUANTIZATION
LIMITER
TRIM
44.1
22.05
48
-30
+4
-60-26
L
R
176.4
192
96
88.2
MIC
LINELINE
MIC
-26
-60+4
-30
HPF
(100Hz)
PRE REC
ON
OFF
LINE
/MIC
FS(kHz)
OFF
ON ON
OFF
ST
MONO
TRACK MODE
24BIT
16BIT
QUANTIZATION
OFF
ON
LIMITER
TRIM
44.1
22.05
48
-30
+4
-60-26
L
R
RL
176.4
192
96
88.2
-26
-60+4
-30
ABS 0
REC END
HPF
(100Hz)
PRE REC
ON
OFF
PLAYREWIND
FS(kHz)
F.FWD STOP
OFF
ON ON
OFFOFF
ON
LIMITER
TRIM
44.1
22.05
48
-30
+4
-60-26
RL
[TRIM] control
[HPF] ON/OFF switch