Filter
Top Products
5-32
Status Listings
Application-Specific Warnings
8028 desc = “A minimum non-zero span is required.”
help = “The application cannot run in a zero span setting. The start and stop
wavelength must be separated by a minimum span. The line number indicates
the line in the specification file which had a start and stop wavelength pair that
did not meed the minimum span requirement.”
8029 desc = “The requested function is not yet implemented.”
help = “The statement within the specification file is not implemented in this
version of the application. The word in parentheses has been reserved for future
use. The statement at the specified line number needs to be removed before the
specification file can be imported.”
8030 desc = “A SETUP statement is needed before SWEEP.”
help = “The wavelength limits of the SWEEP statement are checked against the
wavelength limits in the SETUP statement. This check requires that the SETUP
statement occur before the SWEEP statement. The line number indicates which
SWEEP statement is not preceded by the SETUP statement.”
8031 desc = “The SWEEP limits are outside the SETUP range.”
help = “The start and stop values for the SWEEP statement must be within the
start and stop values of the SETUP statement. The line number indicates which
SWEEP statement has values out of range. The number in the parentheses
indicates which parameter is out of range.”
8032 desc = “The units of the inputs are not compatible.”
help = “The units of the inputs to a math operation need to be compatible with
the operation desired. Addition and subtraction need to have matching units.
Multiplication needs to have a unitless parameter. Division needs a unitless
denominator or the units for the numerator and denominator need to match. The
line number indicates which statement had the mismatched input units.”
8033 desc = “The reference point is outside the SETUP range.”
help = “The reference point value must be within the start and stop values of the
SETUP statement. The line number indicates which statement had the value out
of range.”
8034 desc = “The values are associated with different axes.”
help = “The variables used in a basic math operation like ADD or DIV must be
associated with the same data axis (e.g. wavelength or amplitude). Mixing the
axes values within a single math operation is not allowed. The line number
indicates which statement had the incompatible variables.”
Table 5-7. Application-Specific Warnings (5 of 6)
Error Number Error Description [description/explanation/examples]
book.book Page 32 Monday, January 31, 2000 10:34 AM