Filter
Top Products
EXCEL 10 W7761A INPUT/OUTPUT DEVICE
66 74-2699
Table C4. Configuration Parameters (Right Continued).
Share (SH), Map (MA), Direct Access (DA)
E-Vision (EV): Calibrate (C), Monitor (M),
Parameter (P), Schematic (S)
Hardware Configuration (HW),
Manual Point (MN), Test (TS)
SH MA DA EV HW MN TS Comments
X M X AIUpperLimit: This is the high limit value or the highest value that will be displayed
for this sensor. This value must be between the AIOutputRLow and AIOutputRHigh
and higher than the value specified for AILowLimit.
X M P X DeltaC: The default value of delta for all RIO sensor types is set to zero. With this
default value, the RIO will send the sensor values at the fastest rate of 2 seconds
update rate. However, if the user desires to reduce the network traffic or not receive
the noisy sensor values, a delta value can be specified. This value will force the RIO
to transmit the sensor value when the current value exceeds the last sent value by
the delta amount. RIO will also send the sensor value whenever the time of update
exceeds nciRioSendT. RIO will send the sensor value at the rate of nciRioSendT
regardless of delta change.
X M P X DeltaCO2: Refer to the description for DeltaC.
X M P X DeltaH: Refer to the description for DeltaC.
X M P X DeltaP: Refer to the description for DeltaC.
X M P X DeltaT1: Refer to the description for DeltaC.
X M P X DeltaT2: Refer to the description for DeltaC.
X M P X DeltaT3: Refer to the description for DeltaC.
X M P X DeltaT4: Refer to the description for DeltaC.
X M P X DeltaV: Refer to the description for DeltaC.
X X DO1FlSpeed is how long it takes for the actuator motor to move one cycle of travel
from closed to open. This value would be required if DO1Type were configured to
either Float_Open or Float_Close.
X X DO2FlSpeed is how long it takes for the actuator motor to move one cycle of travel
from closed to open. This value would be required if DO2Type were configured to
either Float_Open or Float_Close.
X X DO3FlSpeed is how long it takes for the actuator motor to move one cycle of travel
from closed to open. This value would be required if DO3Type were configured to
either Float_Open or Float_Close.
X X DO4FlSpeed is how long it takes for the actuator motor to move one cycle of travel
from closed to open. This value would be required if DO4Type were configured to
either Float_Open or Float_Close.
(continued)