12 OptionalHookups
•, • J,o,, ,o,,. Jr, ,o, • o,i • o9,, • t66t • • .,0 • • • oft • ,,661, or,, • ,t6ot • • *t6o .oft • ,t66°, Jtt,t, • otto, ,•Boo6o,ott • tot_,,o,,
You may connect the DVD/VCR several different ways, depending on your existing equipment and your prefer-
ences for sound and picture quality.To determine which hookup is best for you, examine the options on the fol-
lowing pages,then see which best matches your situation. Before you hook up the DVD/VCR, remember:
• Connect the DVD/VCR directly to aT_. If you connect the DVD/VCR to aVCR, then connect the VCR to
the TV, the picture may be distorted by the copyright protection system.
• Turn off the power of all equipment before making any connections.
• Refer to the owner's manuals of your other equipment for additional information.
• Depending on your connection, you may need to purchase additional cables.
• When you use the DVD/VCR AUDIO anclVIDEO OUT jacks on the DVD/VCR, press the DVD/VCR OUT-
PUT button to selectVCR mode (or DVD mode).
Connecting the DVD/VCR to a Stereo TV
9
Otto,
ANT-IN
Jack
Video Cable
Audio Cables
Audio andVideo
IN Jackson TV
I
Connect the antenna or cable to the ANT-IN (Antenna In) jack of your DVD/VCR.
2
Connect the red and white audio cables (supplied) to the red and white DVD/VCRAUDIO OUT
jacks on the DVD/VCR and to the red and white AUDIO IN jacks on the "IV, matching the cable
colors to the jack colors. If the TV has a single AUDIO IN jack, use the white audio cable to connect the
DVD/VCR's white DVD/VCR AUDIO OUT jack to the TV's AUDIO IN jack.You will not use the red audio
cable.
3
Connect the yellow video cable (supplied) to the DVD/VCRVIDEO OUT jack on the DVD/VCR
and to theVIDEO IN jack on theTV. Or, for better picturequality, connectanS-Video cable(not sup-
plied) to the S-VIDEO OUT jack on the DVD/VCR and to the S-VIDEO IN jack on the TV.Youwill not use
the supplied yellow video cable.
4
Connect theTV's power cord to a power outlet. Turn on theTV and set it to the Audio/Video In
channel, which also may be referred to asA/V In or Auxiliary In.This channel usually is located near channel00.
See your'iV owner's manual for details.Or, if you used the S-Video cableat step 3, select the S-Video In channel at
your "i_ See yourTV owner's manual for details.
5
Connect the DVD/VCR's power cord to a power outlet, Press the POWER button, then press the
DVD/VCR OUTPUT button so that the DVD light appears on the DVD/VCR. "HELLO" will appear
briefly on the DVD/VCR's display panel.You should see the DVD logo on theTV screen briefly.If you do not,
check your connections and make sure the'iV is set to the correct Audio/Video In channel. Ifthere isno disc
in the DVD/VCR,"no DISC" will appear on the displaypanel.
