Filter
Top Products
RecordingonaVideoCassetteTape33
I Turn on theTV.
Readand follow the steps below to record a television program
onto a video cassette tape.Before you begin,make sure the Insert a tape in the
DVD/VCR is inVCR mode. Pressthe DVD/VCR OUTPUT button DVD/VCR.
so that the greenVCR light appears on the front of the DVD/VCR.
I
Turn on theTV and set it to channel 3 or 4, whichever chan-
nel the CH3/CH4 switch on the back of the DVD/VCR is set to.
Or, if you connected the DVD/VCR to the TV using audio and
video cables, select the correct audio and video in channel at the
TV. Details are on page 12.
2
Insert a tape with its record tab intact into the cassette
coml_artment of the DVD/VCR. If tape playback begins, press
the STOP button.
3
If the VCR/TV light appears on the front of the DVD/VCR, go to
step 4. If the VCR/TV light does not appear, press the VCR
button, then press the VCR/TV button once.
4
Press the SPEED button until the desired tape speed
appears briefly on the screen. (Detailsabout tape speedare on
page38.)
5
Use the CHANNEL A/v buttons or the Number buttons
to select the "IV channel to be recorded.
6
Press the RECORD button once to start recording. The
RECORD light will appear.
7
To pause the recording, press the PAUSE button once.The
RECORD lightwill flash.To resume recording, press the
RECORD button or press the PAUSE button again. The
RECORD light will come on again.
8
To stop recording, press the STOP button.
3
5
6
PHILIPS
Helpful Hints
If you press the RECORD button
when there is not a tape in the
DVDIVCR,NO CASSETTEwill flash
on the screen.
If you press the RECORDbutton
while a tape without a record tab is
in the DVD/VCR,the DVD/VCR will
eject the tape and PROTECTED
CASSETTECANNOT RECORDwill
flash on the screen.
Other recording optJonsare on
pages 34-40.
Youcan change the tape speed dur-
ing a recording,but some distortion
will appear on the tape.
The DVD/VCR will record in a preset
volume.