Filter
Top Products
TimerRecording(cont'd)37
4
Use the Number buttons (I-8) to select a slot in which to
store the timer recording.There are eight slots. Numbers for open
slots will flash on the screen.
NOTE."If you enter a number for a slot that has already been used ta store a
timer recording,PREVIOUSLYSETPROGRAMwill appear on the screen
briefly.Information about the program in that slot will appear on the screen.
If this happens,press the DISPLAYISTATUS/EXITbutton, then selectanother
number.
5
Use the Number buttons to enter theTV channel you want
to record.
• Cable Users, enter channel numbers as a two-digit number for the
quickest results. For example, to select channel 6, press 0,6. If you
only press the Number 6 button, channel 6 will be selected after a
brief delay.There alsomay be a brief delaywhen you select channels
10,_l,and 12. If you want to select channels 100 and above, enter
channel numbers asa three-digit numbeE For example, to select
channel 117,press I, 1,7.
• Antenna Users, enter channel numbers as a two-digit number for
the quickest results. For example, to select channel 5, press 0,5. If
you only press the Number 5 button, channel 5 will be selected
after a brief delay.You may only select channels 2-69.
• If you are recording from line input,press (3_0to select AV REAR.
• If you are usinga Cable Box/DBS, select the Cable Box/DBS out-
put channel (03 or 04). Set the Cable Box/DBS to the channel you
want to record. Leave the Cable Box/DBS on for the timer record-
ing.Details are on page I0.
©
v¢_
C3 133(33
.....
C_ _ C23
_C_C9
0 0 'O"'O"H_O_
PHILIPS
6
Press two Number buttons for the hour you want the
recording to begin. Press two Number buttons for the
minute you want the recording to begin. Press I forAM or 2
for PM, For example, for 9:30 PM, press 09, 30, 2.
PROGRAM I
CHANNEL 10
TIME ON - - - -
TO CORRECT PUSH CLEAR
END PUSH EXIT
7
Follow the instructions in step 6 to enter the recording's
stop time. (AM or PM will be set automatically.)
PROGRAM I
CHANNEL 10
TIME ON 0930 PM
TIME OFF
TO CORRECT PUSH CLEAR
END PUSH EXIT
Instructions continue on page 38.
Helpful Hints
Entries that do not match the
DVD/VCR's clock or calendar will
cause a question mark to appear
on the screen.
If you are recording from line input,
connect the audio and videocables
to the AUDIO IN and VIDEO IN
jacks on the back of the DVD/VCR.
(Pleasesee illustration on page 40.)