Filter
Top Products
16 TurningonYourDVD/VCR
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
• You can not program channels if you are using a Cable Box or a
Direct Broadcast System.
.
Press the VCR button, then press the POWER button.
"HELLO" will appear briefly on the front of the DVD/VCR.TheVCR
light, theVCR/TV _ight,and the POWER light will appear on the front
of the DVD/VCR.
2
Turn on the TV. Set it to the same channel as the CH3/CH4
switch on the back of the DVD/VCR. The displayshown below
will appear. (If the display does not appear, check your hookups, then
follow the steps on page 17to set up channelsand page 22 to select a
language.)
-_ ENGLISH ON
_SPANOL
MAKE SELECTION OR
USH MENU TO CONTINUE
3
Within 60 seconds, press the PLAY button or the STOP but-
ton to select English or Spanish on-screen displays and
menus.
2
I
_
Turn on the T_.
C3
ocuoU
ocuo
SPEED
OCDO
C300
_ _ --_E_S TITLE 4
4
Press the MENU button.
_CCONNECT ANTENNA OR CABLE 1
TO VCP,
THEN.
PUSH CH UPKEY
OR.
FOP, pLAy ONLY - PUSH STOP
5
Within 60 seconds, press the CHANNEL A button to begin
automatic channel programming. AUTO CH PROGRAMMING
IN PROCESS PLEASEWAIT will appear on the'IV screen.The
DVD/VCR will memorize all availablechannels.When all channels are
memorized, CHANNELS ARE SET will appear on the screen briefly,
then TV programming will appear.
These channels will be availablewhen you want to watch TV while in
VCR mode.To put the DVD/VCR inVCR mode, press the DVD/VCR
OUTPUT button so that theVCR light appears.Then press the
VCR/TV button so that theVCR/TV light appears. Press theVCR but-
ton, then use the CHANNEL and Number buttons to select aTV
channel for viewing.
Helpful Hints
Toskip this feature and play a tape
immediately,insert a tape with its
record tab removed.Or, to skip step
3, press the MENU button.All on-
screen displays will be in English.To
skip step 5, press the STOPbutton.
Channelswill not be programmed,
and CHANNELS NOT SETwill
appear on the screen.
If you try to program channels when
there is no antenna or cable con-
nected to the DVD/VCR.program-
ming will appear to take place,but
eventuallya NO TV SIGNALSmes-
sage will appear. Connect an anten-
na or cable to the DVD/VCR'sANT-
IN (Antenna In)jack and press the
CHANNEL A button again. If chan-
nel programming does not resume,
you may need to follow the steps on
page 17.
You may need to repeat the steps
on this page if a power failure
OCcurs.