Filter
Top Products
Various settings
02
29
En
Replace TV station positions
You can replace the channel positions as you like.
Example: Replace the TV station No. 6 with position
No. 2.
1
Select “CH TUNING” and press ENTER.
2
Select “CH” and press ENTER. Then select the
moving channel position number (6) and press
ENTER.
3
Select “MOVE” and press ENTER.
4
Select the channel position number (2) to which
the selected position at step 2 above is to be
moved and press ENTER. Now these channel
positions were replaced with each other.
CH 6
SKIP OFF
MOVE 6
CH 6
SKIP OFF
MOVE 6
Manual TV station presetting
The Automatic station presetting function (See page
28) memorises the available broadcasts to suitable
CH positions.
Some broadcasts may not be preset correctly by the
automatic tuning system - in this case you can tune
stations manually as follows.
Example: Presetting a station on program position 5.
1
Select “CH TUNING” and press ENTER.
2
Select “CH” and press ENTER. Then select the
channel position number (5) and press ENTER.
3
Select “TUNING” (tuning scale) and press
ENTER.
CH 5
SKIP OFF
MOVE 5
TUNING
4
Press A (rising frequency) or B (falling
frequency) once. The search starts. It stops at
each broadcast automatically. (“A” changes to
“
”) Press B or A repeatedly until the desired
station appears. If the broadcast is too weak
(eg. with a drifting picture), the search will not
stop. If you want to stop, press C/D or B/A.
5
If the tuned-up picture is not satisfactory, press C
or D until the best picture is achieved. Then
press ENTER.
6
Repeat the steps 2 and 5 to preset other TV
stations.
NOTE:
Occasionally, the auto search might catch a weak
signal and stop. If the TV station signal is weak, you
shouldn't store this station. In that case restart the
auto search using B or A.
CH
ENTER RETURN SETUPBACK END
SEARCH F. TUNE
5
SKIP OFF
MOVE 5
TUNING
ENTER
CH 5
SKIP OFF
MOVE 5
2H30301B_En_18_29 8/4/05, 19:2129