Filter
Top Products
58
En
Recording
05
5
Highlight OK and press ENTER.
The TIMER REC SET screen appears and you should see the
new timer recording in the list.
6
Press SETUP to exit.
7
Press TIMER REC. The timer indicator “ ” will appear on the
display and the unit stands by for recording.
• If the program is DVD recording only, the unit will change to VCR
mode automatically. (The DVD mode cannot be selected.)
• If the program is VCR recording only, the unit will change to DVD
mode automatically. (The VCR mode cannot be selected.)
• If the programs are DVD and VCR recording, the unit will turn off.
If you want to use the unit, press TIMER REC again to deactivate
the timer.
•
If the clock symbol ( ) blinks in the display in spite of the
pressing of TIMER REC, the cassette may not have been loaded
yet. (see page 46)
• If the cassette is ejected in spite of the pressing of TIMER REC,
the erase prevention tab of the cassette may have been
removed. (see page 46)
Checking or changing the timer recording
When you want to check the selected timer recording, follow the steps 1
and 2 of “Setting timer recording” and display the TIMER REC SET
screen. To change the timer recording, select the program to be changed
and press ENTER. The changing method is the same as that for the
recording a program for the first time.
Cancelling the timer recording
Display the TIMER REC SET screen.
Select the program you want to cancel and press CANCEL, then the
selected program will be erased from the timer recording list.
In case Timer programs-overlap
Do not overlap timer programs as portions of the conflicting programs will
be lost. The first recording time has priority over the next recording time as
shown in the diagram below.
In this case, the next recording time is delayed a maximum of about
2 minutes. Even when one timer recording is set to start at the same time
as another is set to finish, the later timer recording will be delayed by up to
2 minutes.
NOTES:
•
Recording starts a few seconds
before the preset starting time.
•
You cannot use the timer record-
ing for the both DVD and VCR at
the same time.
•
You can playback the DVD during
the VCR timer recording, and you
can playback the VCR during the
DVD timer recording.
•
If the clock symbol ( ) blinks
when the timer recording ended,
the TV program has not been
completely recorded because of
an insufficient capacity for DVD
disc or video tape. Press TIMER
REC to cancel the timer program.
• After setting the timer program with
VPS/PDC is “ON”, press TIMER
REC then unit will automatically turn
off.
TIMER REC SET
REC REC
TO MODE
VPS/
PDCCHENDSTARTDATE
DVD EP ON702:3501:3527/09(SAT)
VCR SP OFF816:0015:00MON-SAT
DVD XP OFF1218:0017:00SUN
DVD XP OFF702.5401:5428/09(SUN)
NEW
SETUP MENU
8 : 00
11 : 00
9 : 00
10 : 00
Program 1
Prog.1
Deleted Parts
Non Recorded Portion Parts
Prog.2 Prog.3
Program 2
Program 3
Recording
Control Settings
2H30301B_En_54_62 8/4/05, 19:2458