Filter
Top Products
3–Installation
Installing a Switch
3-12 59229-05 A
Install Transceivers
The switch supports a variety of SFP and X2 transceivers. To install a transceiver,
insert the transceiver into the port and gently press until it snaps in place. To
remove a transceiver, pull on the release tab or lever and remove the transceiver.
Different transceiver manufacturers have different release mechanisms. Consult
the documentation for your transceiver.
10-Gbps I/O blades come with port covers in the ports. Before installing the
stacking cables or transceivers remove the port covers. To remove a port cover,
insert a small flathead screwdriver in the cover slot and gently pry the cover from
the port.
NOTE:
The transceiver will fit only one way. If the transceiver does not install under
gentle pressure, flip it over and try again.
CAUTION!
To maintain proper air flow and prevent the switch from overheating, keep
covers installed in unused 10-Gbps ports.
ATTENTION!
Pour assurer un bon flux d'air et éviter une surchauffe du commutateur,
laissez les caches sur les ports 10 Gb/s non utilisés.
VORSICHT!
Um eine Luftströmung aufrecht zu erhalten und eine Überhitzung des
Switches zu vermeiden, lassen Sie die Abdeckung an nicht verwendeten
10GBit/s-Ports installiert.
¡PRECAUCIÓN!
Para mantener un flujo de aire adecuado y evitar que el conmutador se
caliente excesivamente, mantenga las cubiertas instaladas en puertos de 10
Gbps sin utilizar.