Filter
Top Products
133
“Memory Stick
” Operations
2
3
4,5
6
FN
MEM
M
I
X
+–
+–
1
9
100–0001
+–
MEM MIX
MCCAM
LUMI
OVER–
LAP
OFF OK
MCCAM
CHROM
CAMCM
CHROM
M. LUMI
100–0001
+–
MEM MIX
OFF OK
+–
M. LUMI
100–0001
+–
MEM MIX
OFF OK
+–
MEMORY/
NETWORK
VCR
CAMERA
(CHG)
POWER
OFF
ON
MODE
Superimposing a still image in a “Memory Stick” on a moving
picture – MEMORY MIX
Before operation
•Insert the tape you want to use for recording into your camcorder.
•Insert the “Memory Stick” with still images recorded into your camcorder.
(1) Set the POWER switch to CAMERA.
(2) In standby mode, select FN, then press the center z on the control button. The
PAGE1 screen appears.
(3) Select MEM MIX, then press the center z on the control button. The last
recorded or last composed image appears on the lower part of the screen as a
thumbnail image.
(4) Select –/+ on the lower-right corner of the screen, then press the center z on
the control button to select the still image which you want to superimpose.
– : to see the previous image
+: to see the next image
(5) Select the desired mode, then press the center z on the control button. The still
image is superimposed on the moving picture.
(6) Select –/+ on the lower-left corner of the screen, then press the center z on the
control button to adjust the effect.
(7) Select
OK, then press the center z on the control button. The PAGE1 screen
appears.
(8) Select EXIT, then press the center z on the control button. The FN screen
appears.
(9) Press START/STOP to start recording.
Still image