Filter
Top Products
19
Getting started
Charging the battery pack
Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the “InfoLITHIUM” battery pack (F series).
See page 174 for details on the “InfoLITHIUM” battery pack.
(1) Open the jack cover and connect the AC power adaptor supplied with your
camcorder to the DC IN jack with the plug’s v mark facing the lens side.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
(4) Set the POWER switch to OFF (CHG).
The CHG lamp lights up when the charge begins. After the charge is
completed, the CHG lamp goes out (full charge).
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
Note
Prevent metallic objects from coming into contact with the metal parts of the DC plug of
the AC power adaptor. This may cause a short-circuit, damaging the AC power
adaptor.
Step 1 Preparing the power supply
2
1
4
MEMORY/
NETWORK
VCR
CAMERA
(CHG)
POWER
OFF
ON
MODE
CHG lamp