Filter
Top Products
39
Playback
– Basics
You can monitor the playback picture on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder. You can also control playback
using the Remote Commander supplied with your camcorder.
(1) Install the power source and insert a recorded tape.
(2) Press OPEN to open the LCD panel.
(3) Set the POWER switch to VCR. The camcorder turns on and the VCR lamp
lights up.
(4) Select
, then press the center z on the control button to rewind the tape.
(5) Select
, then press the center z on the control button to start playback.
(6) Adjust the volume following the procedure below.
1 Select FN, then press the center z on the control button. The PAGE1 screen
appears.
2 Select VOL, then press the center z on the control button. The screen used
for adjusting the volume appears.
3 Select –/+, then press the center z on the control button repeatedly to adjust
the volume.
– : to turn down the volume
+: to turn up the volume
You can adjust the volume by pressing b/B repeatedly after you select –/+.
(7) Select
OK, then press the center z on the control button. The PAGE1 screen
appears.
5
4
3
6
1
2
VOL
– +
OK
FN
MEMORY/
NETWORK
VCR
CAMERA
(CHG)
POWER
OFF
ON
MODE
VOL bar
— Playback – Basics —
Playing back a tape