Filter
Top Products
136
Copying still images from a tape – Photo save
To stop or end copying
Select END, then press the center z on the control button in step 5.
When the “Memory Stick” is full
“MEMORY FULL” appears on the screen, and the copying stops. Select END, then
press the center z on the control button, insert another “Memory Stick” and repeat the
procedure from step 2.
When the access lamp is lit or flashing
Do not shake or strike your camcorder. Also, do not turn the power off, eject the
“Memory Stick” or remove the battery pack. Otherwise, the image data may be
corrupted.
If the write-protect switch on the “Memory Stick” is set to LOCK
“NOT READY” appears when you select the item in the menu settings.
When you change the “Memory Stick” in the middle of copying
Your camcorder resumes copying from the last image recorded on the previous
“Memory Stick.”
Note
The message “NOT READY” appears when you select PHOTO SAVE in the following
cases:
•There are no images recorded on the tape.
•Images are recorded before the current position on the tape.
In such cases, do the tape photo recording first, or rewind the tape, then select PHOTO
SAVE.