Filter
Top Products
19
Getting Started
8 Click [Next].
Installing of the USB driver starts. The
“Completing the Found New
Hardware Wizard” display appears
when the installation is complete.
9 Click [Finish].
Installing of the USB driver finishes.
Connecting the Remote
Commander to your PC
You can now connect the Remote Commander
(RM-AX4000) to your PC with the supplied
USB mini cable. Connect whenever you want
to verify correct operation of key and button
commands for an XPRESS function, etc., or to
exchange setup data between your PC and the
Remote Commander.
IMPORTANT
•
Do not keep the Remote Commander connected
to the PC when the PC is in standby/
hibernation, otherwise, a malfunction could
occur.
Be sure to disconnect the Remote Commander
from the PC before standby/hibernation begins.
•
Furthermore, do not connect the Remote
Commander to the PC while it is in standby/
hibernation.
Wait until the PC comes out of standby/
hibernation before connecting.
Notes
• The Remote Commander uses the battery when
connected to the PC. When you finish the setup,
unplug from the USB connector.
• Before connecting the Remote Commander to
your PC, be sure to install the fresh batteries in
the Remote Commander.
• Do not disconnect the USB mini cable from your
PC while your PC is communicating with the
Remote Commander, as a malfunction may occur.
• Only connect one Remote Commander to your
PC at a time. Otherwise, you will not be able to
download the settings correctly.
1 Connect the USB mini cable to the
USB connector of the Remote
Commander (RM-AX4000).
2 Connect the USB mini cable to the
USB connector of your PC.