Filter
Top Products
73
Additional Information
Problem
Even if I operate an
XPRESS function, the
input selector of the TV
or RCVR (Receiver/
Amplifier) does not
achieve the correct
status.
Air-Slide does not work
properly.
Trouble with setting mode
Problem
Even if I set a preset
code, the component
does not work.
Learning fails.
Solution
• The Remote Commander memorizes the status of the
component's input selector and power on/off. However, if
you turn on/off the component with the remote control or
operate the component directly, it will not recognize the
current component status. In this case, press the SYNC-UP
button to synchronize the status of the current component
and the Remote Commander.
• If the TV turns off by its own Sleep function, the Remote
Commander does not recognize its status. Turn off the TV
with the Remote Commander. You can also turn off the TV at
the scheduled time with the Timer on the Remote
Commander.
Make sure to slide your finger from the top-left on the LCD
display. If you slide other than from the top-left, Air-Slide
cannot recognize the action.
Solution
• Set the preset code correctly. If the preset code that is listed
first for your component does not work, try all the preset
codes for your component in the order in which they are
listed in the supplied “Preset Code Lists.”
• Some features may not be preset. If some or all of the keys do
not function correctly even after you have set the preset
codes, use the learning function to program the remote
control signals for the component (page 47).
• If you set a preset code after inputting character contents,
they are cleared and return to the original display. Edit the
characters after you decide the component to be used by
setting a preset code.
• Make sure to place the Remote Commander (RM-AX4000)
and remote control about 1-3 inches (3-8 cm) apart. Check the
remaining battery level of the remote control. If low, replace
with new ones.
• Avoid learning in places under direct sunlight or strong
fluorescent light.
• When you teach a remote control unit with an interactive
signal exchange system (supplied with some of Sony's
receivers and amplifiers) to the Remote Commander, the
response signal of component may interfere with the learning
of the Remote Commander. In such a case, move to another
room, etc., where the signals will not interfere.
Continued