Filter
Top Products
(E) 16-3
SIR-3400H / SIR-3032i / SIR-3032W
16. Search
16-2-2. Searching at the Current Recording Start Position
Press the SEARCH key in STOP mode, and then press the REW key.
This returns to and stops at the start point of the current recording.
16-3. Mark Search
Pressing the MRK1/MRK2 key at any recording media position, allows that position to be searched later.
The search stops after the target point is found.
For details about the mark setting, see section 12-12.
Press the SEARCH key, and then press the Mark key for either MRK1 or MRK2 for whichever mark you
want to find.
This searches for the preset mark and stops at that location.
c
. The recording media position information changes each time the MRK1/MRK2 key is pressed.
. When searches are made at a slow speed (1/4, 1/8, 1/16), the marked points and target may be displaced
by up to three seconds from the real-time clock value.
16-4. Address Search
This function searches target by the address value.
It is controlled from the host computer by Telnet (See section 17).
MONITOR
UP DN
REW key
SEARCH key
FF key
MRK1 key MRK2 key