Filter
Top Products
(E) 5-1
SIR-3400H / SIR-3032i / SIR-3032W
5. Description of Transport Mode
5-1. Transport Modes
Mode name Description Lit lamp
(over key)
STOP This is stopped status. STOP
This is the mode entered when the power for the recording unit is
turned on. Be sure to set to this mode before turning off the power.
E-E This mode is for adjusting the range and offset while checking the REC
signal on the screen before actual recording.
REC This mode is for recording the data to recording media. Monitoring REC, FWD
can also be performed at the same time.
REC-PAUSE This mode pauses REC mode. When the pause is cancelled, the ID REC, FWD,
is sent, and the next recording data is processed using the next ID PAUSE
number.
FWD This plays back the data recorded on the recording media. FWD
FWD-PAUSE This mode pauses the FWD mode. When the pause is cancelled, FWD,
playback starts from the data at that point. PAUSE
FF This fast-forwards data playback. FF
REW This rewinds data playback. REW
ID skip
This searches and plays back the start of the current or next ID block.
SEARCH This performs a search. The following searches are available.
(See “16. Search.”)
Start ID search This searches the ID at the start position for each recording.
ID/INDEX This sets the ID/INDEX number and searches the start.
number search
Mark search This searches the Mark1/Mark2 that were marked in the recording
media.
Address search This searches designated addresses (controlled by Telnet).
Real-time clock This searches the specified real-time clock value written on the
search recording media (controlled by Telnet).
Manual search This performs 16x-speed fast-forwarding or fast-rewind.