Filter
Top Products
(E) 13-1
SIR-3400H / SIR-3032i / SIR-3032W
13. Other Settings
13-1. Changing to the Address, Amount of Recording Media Remaining, or
Time Display
When the LCD screen is changed to the Measurement screen, the display can be changed to address, amount
of recording media remaining, or time display.
1 Press the F3 key in the Measurement screen.
Each time F3 key is pressed, the display for ADDRESS, REMAIN, and S-TIME/R-TIME switches as
below.
Transport mode Display
E-E, REC-PAUSE, REC, and ADDRESS → REMAIN → S-TIME (Y, M, D) → S-TIME (H, M, S)
STOP from one of these modes → ADDRESS
FWD, FF, REW, and ADDRESS → REMAIN → R-TIME (Y, M, D) → R-TIME (H, M, S)
STOP from one of these modes → ADDRESS
13-2. Clearing the Peak Indicator and Over Indicator
When the response characteristics of the peak indicator are set to Hold, the peak indicator and over indicator
are cleared.
1 Press the F4 key in the Measurement screen.
This clears the Peak indicator and Over indicator.
13-3. Switching the Speaker or Earphone Playback Signal Source
When the LCD screen is changed to the Measurement screen, the playback signal source for the speaker or
earphone jack can be changed.
1 Press the SPEAKER key in the Measurement screen.
The playback signal source for the speaker or earphone jack switches between the recorded voice
annotations and the analog data signal. The current playback signal source is shown in the status display
area of the LCD screen.
Mark Description
The voice annotation recorded into the voice channel is output from the speaker or earphone
jack.
The data signal of the analog channel is output from the speaker or earphone jack.
13-4. Adjusting the Playback Volume
This procedure adjusts the playback volume of the speaker or earphone.
The volume of warning buzzer accompanied by the warning message cannot be adjusted.
1 Turn the VOL knob on the recording unit rear panel.
Be careful that you do not listen to earphones (sold separately) at a high volume for extended
periods of time.