Filter
Top Products
13-2 (E)
SIR-3400H / SIR-3032i / SIR-3032W
13-5. Changing the AC Voltage
Be careful to use the correct voltage since usage of an incorrect voltage can lead to a fire or failure
of the unit.
At shipping, the AC voltage is set to either 100/120 V or 220/240 V. The setting is displayed on the
sticker on the AC voltage selector switch. If you peel off the sticker and change the voltage, be sure
to always re-check the usage voltage before using.
c
. When the AC voltage selector switch is set to AC 100/120 V, supplying AC 198 to 250 V may damage the
recording unit's internal circuitry.
. When the AC voltage selector switch is set to AC 220/240 V, the recording unit will not operate when
supplied with AC 90 to 132 V.
1 Use the AC voltage selector switch on the rear panel of the respective unit to change the voltage.
Move the switch to the selected voltage side.
Left side : 100/120 V (allowable 90 to 132 V)
Right side : 220/240 V (allowable 198 to 250 V)
13. Other Settings