Filter
Top Products
114
Display the video of the selected camera.
Record Setting
In the Recording setup windows, click OK to accept the new settings, click Exit to exit without
saving, and click Default to revert back to original factory setting.
(2)
(1)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable
the ALL check box. To select more than one camera, Right click on the camera icon. To select
one camera only, Left click on the camera icon. The camera icon turns red when it is selected.
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select the
recording mode and click the ~ button. If you want to only record at a particular time, click the
colored block beside the recording mode then click on the time blocks. When the system starts
recording a red triangle mark would appear at the upper left corner of the screen. The recording
modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path
- Motion Recording
Start recording the video from the selected camera only when the system detects
movement. Once a motion is detected, the system automatically saves the previous
frames and stop based on the Start Record Prior and Stop Record After settings.
- Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is
detected and if there is no motion, it records at the minimum frame rate setting. Set the
maximum and minimum frame rate setting in (5) Frame Rate
section.
- No Recording
The system won’t do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is
detected. When it detects a motion, a green triangle mark would appear at the upper left corner of
the screen.
(4) Quality
Adjust the video quality. The higher the value, the lower the compression level and uses more