Filter
Top Products
2.1 Starting to watch television 19
2.1.1 Volume control
Use the and controls on the remote to alter the volume
to a comfortable level. You may need to adjust the volume
on your television set too, so that the controls on the PVR’s
remote give you a good range of control, without too much
noise or distortion.
To temporarily switch off the sound, press the button on
the remote control. Press it again to restore the sound to the
previous level.
The PVR’s remote control changes the volume or mutes the
sound sent through the TV SCART connector, the left and right
audio connectors, and the RF OUT. Neither the volume nor the
mute buttons affect the signal sent to the VCR SCART connec-
tor, or the S/PDIF optical connector.
2.1.2 Changing channels
The simplest way of changing channels is to press the appro-
priate numbers on the remote control; if a channel number
has more than one digit, don’t wait too long between each key
press.
For example, to switch to Five, press 5. To switch to ITV4,
press 3 then 0.
You can also use the and buttons on the remote control;
press either of these keys to move to the next or previous chan-
nel in the list. They’re a good way of just flicking through the
channels to see what’s on —as each channel appears, the In-
formation box will pop up, telling you the name of the current
programme.
If you’re not sure which channels you have, or you can’t re-
member the correct numbers, press the List, or OK/List but-
ton on the remote control, and you’ll see a display like this: