A SERVICE OF

logo

14
STEP C-4
Rear Camber links (Quantity: 2) Use the long rod ends on 24mm turn-
buckles for the rear rear camber links. Assemble as shown. Snap in the
metal hollow ball connectors. The center-to-center distance should be
38mm.
STEP C-5
Drag Link (Quantity: 1) Locate the 36mm turnbuckle and (2) short rod
ends for the drag link. Assemble as shown. Snap in the metal hollow ball
connectors. The center-to-center distance should be 50mm.
STEP C-6
Steering arm (Quantity: 1) Locate the 20mm threaded rod and (2) short
rod ends for the steering arm. Assemble as shown. Note that the rod
ends are turned 90-degrees from each other. Snap in the metal hollow
ball connectors. The center-to-center distance should be 30.5mm.
STEP C-7
Locate the upper control arms, (2) 26x4mm turnbuckles, the two upper
ball joints.
STEP C-3
Snap in the metal hollow ball connectors with needle nose pliers.
30.5mm
50mm
38mm