A SERVICE OF

logo

20
F-13
Use CA (cyanoacrylate) glue to glue the bushing into the graphite rear
brace. Note the orientation of the brace. The plastic bushing pushes into
the hole from the top. Set this assembly aside.
F-14
Rear Side Plates:
Locate the right rear side plate, (1) belt tension cam, (1) 5x11x4mm ball
bearing, and (1) 10x15mm ball bearing.
F-15
Press the 5x11x4mm ball bearing into the pulley shaft hole in the right
side plate.
F-16
Press the 10x15x4mm ball bearing into the belt tension cam.
F-12
Locate the graphite rear brace and the plastic bushing.
Belt tension
cam