A SERVICE OF

logo

Open as PDF
next previous
16
STEP D-6
Use the u-joint assembly tool to push the remaining pin into the stub
axle yoke. Again, apply pressure down while pushing so that both ears
will spread. Repeat steps D-1 to D-6 for the remaining 3 female drive
shafts and stub axles.
STEP D-7
Find (1) Differential output yoke, (1) metal u-joint ball (spider), and one
external-splined drive shaft (male).
STEP D-8
Assemble the (4) differential output yokes, male drive shafts, and metal
U-joint balls using the same procedure outlines in steps D-4 to D-6.
STEP D-9
All of the drive shafts need to be shortened to allow full suspension trav-
el. Use a hobby knife to cut 2mm from the ends of the male and female
drive shafts.
STEP D-5
Insert another pin into one ear of the stub axle joint.