17
STEP D-10
Insert (2) 3x3mm grub screws into each of the (4) differential output
yokes. Do not screw them in all the way. Set the drive shaft assemblies
aside.
BAG E: Sway Bars
E-1
Sway Bars: Locate the bag labeled “Sway Bars.” Find the (4) nylon
sway bar links. Locate (4) 3x5mm roundhead machine screws
(Hardware Bag).
E-2
Install a sway bar link onto each front suspension arm as shown. Note
the orientation and hole location
used. The recessed side of the
ball joint should face down. After
the car is assembled, you will be
able to adjust the action of the
sway bars by simply loosening
the screws and sliding the sway
bar link to the next position.
E-3
Attach the remaining sway bar
links to the rear suspension arms
with (2) 3x5mm roundhead
machine screws. Again, note the
orientation and hole location
used. Set the front and rear sway
bars aside for installation later.
BAG F FRONT DIFFERENTIAL HOUSING
F-1
Front differential housing: Locate the front differential housing and cover,
(2) 3x25mm buttonhead machine screws, and (2) 3mm flange nuts.
