Traxxas 4801 Manual

A SERVICE OF

next previous

8

STEP A-6

Secure the bottom shock assembly with a C-clip. Use C-clip pliers to

compress the C-clip and and insert it into the groove in the bottom of the

shock body. If you do not have any C-clip pliers or strong, sharp tweez-

ers, try inserting one side of the C-clip into the groove and then carefully

push the other side into the groove with a small screwdriver. Wear pro-

tective eyewear when working with the C-clips.

STEP A-7

Locate one of the 32mm shock shafts and snap a small E-clip into the

bottom groove on each.

STEP A-8

Find one of the two-hole piston heads and place it onto the shaft. The

picture shows two holes and two molding indentations. The holes are all

the way through the piston head.

STEP A-9

Secure the piston head with a small E-clip

STEP A-10

Locate the two blue O-Rings. Slide the O-rings over the grooved end of

the shaft. These are shock travel limiters.

hole

hole

molding

indention

O-Rings

molding

indention