43
I-33
Use a 1.5mm allen wrench to tighten the 3x3mm grub screws against
the differential output shafts. Do not overtighten these screws or you will
strip the plastic. Repeat for the other side.
I-34
Locate the female driveshaft assemblies (with the stub axles). Insert the
male halfshaft into the female halfshaft assembly.
I-32
Locate the male front drive shaft assemblies (with the differential output
yokes). Slide the differential output yokes onto the differential output
shafts. Note that the flats on the shaft must align with the flats molded
inside the differential output yokes.
I-30
Insert the threaded metal inserts
into the front axle housings. If
necessary, use a drop of CA glue
(Super Glue™) on each to pre-
vent them from falling out during
assembly.
I-31
Insert the bearings into the front axle housing.
