40
I-15
Position the front bumper with the lower suspension arm mount as
shown. The tab on the bumper locks into the lower mount.
I-17
Attach the front suspension assembly,
bumper, and lower suspension assembly to
the chassis as shown with (4) 3x20mm
countersunk machine screws.
I-16
Position the front differential housing onto the lower suspension arm
mount. The tabs on the side of the differential housing should engage
the slots in the lower mount.
I-18
Locate your throttle servo (not included
with the kit). Install the throttle servo into
the right stiffener with the output shaft
positioned as shown. Secure the servo
with (4) 3x8mm buttonhead machine
screws. Route the servo
lead through the slot in the
bottom of the right stiffener,
under the fuel tank, and
then over to the receiver plate.
I-19
Position the upper chassis assembly
onto the lower chassis as shown.
Note that the front belt must be
placed around the pulley as the
upper chassis is positioned.
