A SERVICE OF

logo

Open as PDF
next previous
22
F-23
Snap a large E-clip into the groove in the top of the blue-anodized brake
cam.
F-24
Insert the end of the brake cam (opposite the E-clip) into the hole in the
bottom corner of the right stiffener. Twist the brake cam so that the flat
side, which is cut into the shaft, faces the graphite brake disk.
F-25
Insert one of the metal brake pads between the brake cam and the
brake disk. The brake pad will fit into the flat cut into the brake cam
(shaft).
F-26
Slide one of the 3x15mm caphead shoulder screws through the top hole
in the remaining brake pad, and then through the top hole of the first
brake pad. Install the screw into the hole in the stiffener and tighten until
it stops.
F-22
Slide the graphite brake disk onto the brake hub.
Flat side
3x15mm caphead
shoulder screws