A SERVICE OF

logo

Open as PDF
next previous
51
K-4
Locate the receiver battery/ switch harness which came with your radio
system (not included in the kit). Install batteries in the battery holder.
Stretch a rubber balloon over the battery holder to protect it from fuel
contamination.
K-5
Use the large zip strap to secure the battery to the graphite top plate.
Route the wires in front of the fuel tank and over to the receiver plate.
K-6
Mount the on/of
f switch in the receiver plate as shown.
K-2
Attach one end of the steering link to the servo saver with the 3x15mm
countersunk machine screw and the 3mm nylon locknut.
K-2
K-3
Attach the remaining end of the link to the inside hole in the left bell-
crank with a 3x12mm countersunk machine screw. Note: If your radio
system does not have steering end point adjustment, we recommend
that you attach the link to the outside hole on the bellcrank. This will pre-
vent the steering servo from trying to push through the inboard steering
stops.