A SERVICE OF

logo

Open as PDF
next previous
56
K-29
Attach the pipe support to chassis. The end of the pipe wire has been
bent up to accomodate the pipe. The bend is visible in Step K-31.
K-31
Insert the end of the wire through the hole in the end of the pipe.
T
ighten
the grub screw in the end of the pipe against the wire (arrow).
K-30
Attach the the coupler
to the end of the pipe.
Fit the other end of the
coupler over the end of
the header.
K-28
Locate your tuned pipe (not included in kit), the pipe coupler, the exhaust
hanger wire, 3x10mm countersunk machine screw, and 3mm locknut.
K-27
Fasten a screw collar to one end of the brake rod with a 3mm grub
screw.