A SERVICE OF

logo

25
F-37
Locate the left side plate assembly, the 50-groove belt, the remaining
ball differential, and the graphite rear shock tower assembly.
F-38
Position the ball differential so that the differential pulley is offset toward
the right side plate. Place the belt around the differential pulley.
F-39
Fit the belt around the 15-groove pulley and then insert the differential
output shaft into the 10x15x4mm ball bearing in the right side plate.
F-40
Install the left side plate as shown by sliding the 10x15x4mm ball bear-
ing onto the remaining ball differential output shaft.
F-41
Fasten the rear side plates together by installing the rear graphite shock
tower as shown, with (4) 3x10mm countersunk machine screws.