52
K-9
fit the steering servo between the upper
and lower chassis assemblys. Attach the
servo to the lower chassis with (2) 3x10
mm countersunk machine screws. The
front holes will accommodate two different
standard servo sizes.
K-10
Locate your receiver. With the battery switch off, connect the two servo
leads and the battery lead according to the manufacturer’s instructions.
Gather all of the wires (including the antenna wire) at one end of the
receiver.
K-11
Stretch a rubber balloon over the receiver to protect it from fuel contami-
nation. Secure the receiver to the receiver tray with a zip tie. Neatly bun
-
dle the servo leads with small zip ties. the wiring should be clear of the
steering mechanism and the exhaust system. Note picture not shown
with balloon.
K-8
Attach the steering servo to the steering servo mounts with the (4)
3x8mm buttonhead machine screws. Note that the servo output shaft is
on the right in the photo.
K-7
Locate your steering servo, the steering servo mounts, (2) 3x10 mm
countersunk machine screws, and (4) 3x8mm buttonhead machine
screws.
