A SERVICE OF

logo

Open as PDF
next previous
30
G-7
Locate the drive hub. Set the adjustment set screw to be
flush with the counter bore as shown. Slide the drive hub
onto the two-speed shaft as shown. Note that the adjusting
screw is behind the set screw in the photo (arrow 2). Align
the set screw with the flat on the two-speed shaft and then
tighten the set screw.
G-8
Align the set screw with the flat on the two-speed shaft and then tighten
the set screw. Note: the adjustment is to the back.
G-9
Slide the two-speed gear and hub assembly onto the two-speed shaft.
G-10
Locate a 20-groove pulley
, pulley flange, (1) axle pin, and a large E-clip
(5mm).
G-6
Locate the 41-tooth spur gear and another snap ring. Slide the spur
gear onto the hub so that the pins in the hub engage the holes in the
spur gear. Install the snap ring.
Two speed adjustment
screw.
Set screw for
the shaft.
2
Screw is flush
with edge of
counter bore.