38
I-5
Slide a bellcrank spacer over each bellcrank post.
I-6
Attach the left bellcrank to the graphite top plate assembly with a
3x8mm buttonhead machine screw. Attach the right bellcrank post to the
top plate assembly with a 3x10mm buttonhead machine screw. The bell-
crank spacer should be sandwiched between the top plate and the bell-
crank. Study the photo closely to ensure that you have the left and right
bellcrank placement correct.
I-7
Front Suspension:
Locate the lower front suspension arms, the lower front suspension arm
mount, the graphite tie bar, (4) small e-clips, and the 45.5mm hinge
pins.
I-8
Snap a small E-clip into one groove of each of the hinge pins.
I-9
Attach the lower front suspension arms to the front suspension arm
mount by inserting 45.5mm hinge pins through the pivot points. Carefully
notice how the arms are positioned in the photo.
The sway bar link on
each arm should point up.
Left
bellcrank
Boss
3x8mm
3x10mm
