A SERVICE OF

logo

31
G-11
Insert an axle pin into the hole in the two speed shaft.
G-12
Slide on the 20-groove pulley so that the slot in the pulley engages the
axle pin in the shaft. Slide on the pulley flange with the beveled side of
the flange facing the pulley.
G-13
Secure the 20-groove pulley with a large (5mm) E-clip.
BAG H
Upper Chassis and Bellcrank Assembly:
H-1
Locate the graphite upper chassis plate, battery plate, bearing block, (2)
3x6x8.9 bearing block spacers (blue anodized), (2) 3x6x10.75 bearing
block spacers (blue anodized), (2) 3x20mm buttonhead machine
screws, two 3x20mm countersunk machine screws, (4) 3mm locknuts,
and (2) 5x1
1mm ball bearings.
H-2
Insert the 5x1
1x4mm ball bearings into the bearing block.