Traxxas 4801 Manual

A SERVICE OF

next previous

42

I-27

Position the upper control arm assembly on the upper chassis as

shown. Note that the assembly must go through the middle of the front

belt. Fasten the assembly to the upper chassis with (2) 3x15mm button-

head machine screws in the front and (2) 3x12mm buttonhead machine

screws in the rear.

I-28

Locate the thick and thin caster spacers. Insert (1) thick spacer in the

front location and (1) thin spacer in the rear location on each upper control

arm.

I-29

Locate the front left and right stub axle housings, (4) threaded metal

inserts, (4) 5x11x4mm ball bearings, and (4) 3x8mm caphead machine

screws.

I-26

Attach the upper front control arms to the upper control arm mount by

inserting 33.5mm hinge pins through the pivot points. Secure the oppo-

site end of each hinge pin with a small E-clip.

I-25

Snap a small E-clip into one groove of each of the hinge pins.

3x15mm

3x12mm