E
E-6 Micro PLC Programmer’s Guide – April 1994
GFK-0804B
The Display Software Menus
Main Menu
A = Auto Operation
M = Manual Operation
S = Set up Colors
R = Set up Message Register
H = Help
Esc = exit
Auto Polling Operation
C = Create/Change Screen file
E = Execute Screen file
M = Edit Messages file
H = Help
Esc = Back to main menu
Manual Operation
Q, I, R = Read Q,I,R Table Word
H/L = Hi/Lo Set Output Table Bit
W = Write Single Register
M = Multiple word/byte Read
C = Create/Change Register file
B = Write Register Bank file
E = Exception Report
R = Report Device Type
P = Help
Esc = Back to main menu
Set up Screen/Border Colors
Up arrow or F = + Text
Down arrow or D = –Text
Right arrow or B = + Border
Left arrow or V = – Border
Set up Message Register
Enter ID of device :
Enter pointer register number :
To Create or Execute Auto-polling Screens: Select A from the Main menu. For
creating Auto-polling screens, see the instructions on page E-13. For executing
Auto-polling screens, see the instructions on page E-21.
To Manually Poll a Micro PLC: Select M from the Main menu. See page E-9 for
instructions.
To Change Data in a Micro PLC: Select M from the Main menu. See page E-9 for
instructions.
To Download Registers to a Micro PLC: Select M from the Main menu. See page E-11.
To Change the Software Screen Colors: Select S from the Main menu. See page E-7
for instructions.
To Create or Edit System Messages: Select A from the Main menu. See page E-19 for
instructions.
To Set Up a Micro PLC (or Other Device) to Control System Messages: Select R
from the Main menu. See page E-20 for instructions.
To Exit to DOS: You can exit to DOS from this menu by pressing the ESC key. You can
also exit to DOS at any time by pressing Control–Break.