Filter
Top Products
A
A-1
GFK-0804B
Appendix A Using Directories
This section gives some advice on organizing the Micro PLC programming directory structure
on your hard disk.
If you installed the programming software using the default values, the programming files
are in a directory named \MICRO on your disk. You also have the following directories:
\MICRO
MICRO.EXE the programming software
MICRO.CFG a configuration file that contains information about
your serial port, display, and data tables format.
\COMM
\DDE
Loading and Saving Files
When using the Load or Save command, you need to enter a filename. You can either:
A. Enter a filename without a path:
PROG1
In this case, PROG1 is assumed to be in the present directory. If you started running
MICRO.EXE in the \MICRO directory, the file PROG1 is really assumed to be
C:\MICRO\PROG1, etc...
OR:
B. Enter a path with the filename:
C:\MICRO\RIVETER\PROG1
When you specify the entire filename including drive, directories, and filename, it
doesn’t make any difference which directory you are in when you Load and Save.